Warning: file_get_contents(/home/content/62/10983362/html/timer-relay/wp-content/plugins/amzn/templates/kefuang/inlinesingle.html) [function.file-get-contents]: failed to open stream: No such file or directory in /home/content/62/10983362/html/timer-relay/wp-content/plugins/amzn/amzntemplates.php on line 29
Do you wish to know the latest news about 12v mini relay, Do you want to be the initial in line in regards to the developments on 12v mini relay, Are you itching to get as much as the minute data,
This artice will have the information which you need that is definitely fresh from the source! You may subscribe to our feeds or you can join the mailing list, so you can ensure that that you are in together with the times,and ahead of absolutely everyone!
There was an error connecting to the Amazon web service, or no results were found for your query.
You will come across plenty of matters to grow to be thought to be about %keywords%, and those that happen to become heavily into the subject are most likely to choose to know a great deal a lot more. Even though this post serves as no a whole lot greater than an introduction, practically nothing stops you from placing the data to exceptional use.
Kazoo M asked Mini controller project required?
I am somewhat new to this type of control device and require your assistance as to how i should approach my project. I require the ability to turn on/off six independent outputs that will later be configured to bias 6 basic common emitter transistors (2N2222). The latter small relays (12VDC/1A) will control an audio path etc.. However, the controller will be required to remember its last state before being turned off, the latter will allow the controller once turned on to resort back to its last state. Example: The 6 relays (outputs) during the time the conrtoller is ON may be in different positions (open ~ closed), once the controller is turned OFF and then back ON it is important that the latter control states are re-initiated prior to when the controller was turned off etc... *** This is not a homework project and i have no desire to use latching relays *** Artwork concept: http://i4.photobucket.com/albums/y109/emperor500/minicontrollerproject.jpg Thank you
And got the following answer:
See my answer under: http://answers.yahoo.com/question/index;_ylt=AkfvLCa5Jt0Rcb.vPVZ8AQgjzKIX;_ylv=3?qid=20080614130311AAWB3li PIC has a nanowatt line which uses little power. Here's a selector: http://www.microchipdirect.com/Chart.aspx?branchId=54&mid=1&treeid=1 The 16F882 is a nice device. It has the self-write, lots of I/O, and is way overkill, but still only costs a buck. It runs from 2V to 5.5V, so you need regulator to run it off 12V. 3V lithium cell backup with germanium diode could keep memory. Run it at 32kHz to get probably about a 10uA draw. Use the watchdog timer to cut this to about 2uA. Also, can use self-write variant for permanent storage, possibly in lieu of backup battery. Also have LCD driver variants, perhaps they have higher voltage outputs that could reduce part count. I would use n-channel FETS for the drivers, not the 2N222's. This allows the PIC output drivers to stay at legal voltages, because the gates are isolated. Make sure the voltage you run the PIC at turns on the FET adequately. I believe some are in the 2V range, many are within 5V. U can use LED's instead of LCD. Use 1mA or 2mA diodes, big resistors to drop current low if less intensity acceptable. Put them in parallel with solenoids. Put the LED power supply thru a single additional FET if you want to be able to turn them off for power saving.