Warning: file_get_contents(/home/content/62/10983362/html/timer-relay/wp-content/plugins/amzn/templates/kefuang/inlinesingle.html) [function.file-get-contents]: failed to open stream: No such file or directory in /home/content/62/10983362/html/timer-relay/wp-content/plugins/amzn/amzntemplates.php on line 29
Warning: file_get_contents(/home/content/62/10983362/html/timer-relay/wp-content/plugins/amzn/templates/kefuang/inlinemulti.html) [function.file-get-contents]: failed to open stream: No such file or directory in /home/content/62/10983362/html/timer-relay/wp-content/plugins/amzn/amzntemplates.php on line 29
Do you want to know the most recent news about current control relay, Do you need to be the initial in line concerning the developments on current control relay, Are you itching to have up to the minute details,
This artice will have the particulars that you want that is fresh from the source! It is possible to subscribe to our feeds or you may join the mailing list, so you could be certain which you are in with the occasions,and ahead of every person!
There was an error connecting to the Amazon web service, or no results were found for your query.
This blog began out as a effortless repository of uncomplicated information, then it grew to turn into a spot on the internet that is certainly devoted to %keywords%. We thank definitely everyone who contributed to our weblog as well as the folks who painstakingly take time for you to read and comment – to make our web site the top that it may be.
I need to be able to control a drill motor (18v, 50A) with a 5v signal from a development board. I know I can use a MOSFET to control the high voltage, but that would still require a momentary 20V signal going to the gate of the MOSFET (which is higher than the 5v) signal. Someone recommended using a MOSFET Driver, but I'm not sure what that is or how to create one. If someone could give me some more info on how to do this or provide examples I would greatly appreciate it.
And got the following answer:
You don't say what type of control. But if all you want is to turn the motor on or off, then a thyristor will do the trick. Because of the commutator on the motor, the SCR will shut off when the gate current is removed. You can even get sensitive gate SCRs if the current is an issue on the 5V signal. You could also just use a solid state relay or mechanical relay. If you're using the MOSFET for some particular reason and don't have voltage higher than 18, then you could use a DC-DC converter to gain the potential and used a BJT intermediate stage.