Warning: file_get_contents(/home/content/62/10983362/html/timer-relay/wp-content/plugins/amzn/templates/kefuang/inlinesingle.html) [function.file-get-contents]: failed to open stream: No such file or directory in /home/content/62/10983362/html/timer-relay/wp-content/plugins/amzn/amzntemplates.php on line 29
Are you trying to find testimonials about relay catalogue, read the item testimonials, we will tackle several aspects, fundamentals as well as other points of interest about relay catalogue. Numerous readers discover that this blog is a good spot to start if you need to purchase the prodct about relay catalogue.
We will give detailed sources like critiques, photos, articles, videos and links which may possibly be of superior use for all those who wish to make a more detailed study about it.” in case you want to get far more information about relay catalogue. just read it as under.
There was an error connecting to the Amazon web service, or no results were found for your query.
This blog started out as a easy repository of very simple information, then it grew to develop into a spot on the net that’s definitely committed to %keywords%. We thank absolutely everybody who contributed to our blog and also the individuals who painstakingly take time to study and comment – to produce our web site the top that it could be.
jes asked how to wire an alternating relay?
Ive never wired one of these before. I wired it like I would a normal relay, switching the coil, but its not alternating. I found a schematic for it and I think I have it figured out but I wanted to get someone else's opinion. The schematic is at http://www.macromatic.com/literature/catalog/pdf/arp-1.pdf I think I need pin 4 always hot 3 is neutral pin 5 the float switch to turn it on (and alternate) jumper between 1 and 5 loads on 2 and 8 and just wondering are pins 6 and 7 a set of normally closed contacts?
And got the following answer:
You must be referring to ARP-SPDT relay Pin 4 is connect to the live line and pin 3 is connected to the common line (neutral is used when you have a 3 or more wire system with at least 2 live lines and one neutral). It is necessary to have pin 3 and 4 connect properly for this relay to operate properly. the power MUST ALWAYS be supplied to pins 3 and 4. If your float switch is a single pole single throw switch or a single pole double throw switch; then you MUST have the jumper from 1 to 5. You 2 loads are conected to pins 2 and 8 M1 and M2 are NOT necessarily motors but likely motor starter relays. The contacts in these alternating relays are NOT designed to control motor loads with high inrush currents like you get with sump pumps. they are rated at 10 amps Contact rating: 10A @ 240V AC/30V DC, 1/2HP @ 120/240V AC (N.O.), 1/3HP @ 120/240VAC (N.C.) Contact 1 to 2 is a normally closed contact and therefore should not exceed a load greater than 1/3 HP at 120/240 volts Even though contact 1 to 8 is a normally open contact, you still should not exceed 1/3 HP at 120/240 volts