Warning: file_get_contents(/home/content/62/10983362/html/timer-relay/wp-content/plugins/amzn/templates/kefuang/inlinesingle.html) [function.file-get-contents]: failed to open stream: No such file or directory in /home/content/62/10983362/html/timer-relay/wp-content/plugins/amzn/amzntemplates.php on line 29
Do you should know the most recent news about relay logic control, Do you should be the initial in line concerning the developments on relay logic control, Are you itching to obtain up to the minute information and facts,
This artice will have the information that you simply need which is fresh in the source! You can subscribe to our feeds or you are able to join the mailing list, so you will be able to make sure that you simply are in together with the occasions,and ahead of everybody!
There was an error connecting to the Amazon web service, or no results were found for your query.
The subsequent time you know you take place to be acquiring the brief end with all the stick, come back and invest us a take a look at. We would prefer to hear your comments regarding the post so please take a moment and drop us a line.
High quality is our passion together with the cause we produced our site. We want to spread the word about %keywords% in order that no one has to place up with mediocre and second extremely most effective again.
Andrew Kiernan asked How to wire a relay with a H bridge?
I am attempting to make a circuit which will control the direction of an electric DC motor please see http://i1304.photobucket.com/albums/s533/Andyrew_Kiernan/Drawing1_zpsc651af09.jpg However when powered the motor runs but when the normally open switch is pressed the motor stops were as I though it would run in reverse. Can anyone advise on the issue?
And got the following answer:
Why use a bridge when the relay will do the job by itself. The purpose of the H bridge is to control the direction of the motor via logic signals, where you don't want to use a relay. But anyway... The logic inputs to the H bridge need a pullup resistor, say 1k, if you are going to operate those with switches. edit: I mean pull down, as when there is no connection the inputs will float high. Pull downs don't work well, but 200 ohms may work. But I can't make sense of the switches. You have 3 different types of switches, are they all controlled by the relay? The larger switch shown seems to be a manual switch, and that is all you need, what does the relay do?