Warning: file_get_contents(/home/content/62/10983362/html/timer-relay/wp-content/plugins/amzn/templates/kefuang/inlinesingle.html) [function.file-get-contents]: failed to open stream: No such file or directory in /home/content/62/10983362/html/timer-relay/wp-content/plugins/amzn/amzntemplates.php on line 29
Do you want to know the latest news about reverse current relay, Do you should be the initial in line in regards to the developments on reverse current relay, Are you currently itching to get up to the minute info,
This artice will have the facts that you just need to have that is fresh from the supply! You could subscribe to our feeds or you will be able to join the mailing list, so you could be sure that you are in with the occasions,and ahead of every person!
There was an error connecting to the Amazon web service, or no results were found for your query.
If you found the write-up valuable, please pass on our data and facts for your buddies. Lots of from the troubles discussed inside the write-up are usually not widely identified.
When you’d like substantially much more articles like this, please take a few moments to offer us your feedback. Even though %keywords% is typically discussed, access to info about it might be hard to locate. Please come back and take a look at us once again, we will have extra high good quality articles for the reading pleasure.
Is there any way that i can automatically change the direction of current in a DC circuit after a predefined time. that means i will have to use H bridge is this device ready made available or i have to make it also cant understand how to use electronic timer so it reversed direction after lets say 20 secs I am just using a simple motor for which i want to change its direction automatically after 20 sec is there any IC available to do that
And got the following answer:
The suuply is reversed by a double pole changeover switch, one changeover for each leg. For automatic operation, this switch can be a relay, that is in turn operated by a timer device. If there is significant power involved it is important to make sure the contacts break well before the other pole makes in the changeover. That is, a dead zone. With motors, you might need to stop the motor before reversing it. A solid state switch that does the same is a H bridge. The circuit is wired like the letter H with electronic switches on each leg (4 of them) and the load on the horizontal of the H. One diagonal pair is on for one direction, and the other pair for the other direction. This is commonly used for reversing DC motors. There also needs to be a dead zone between switching one pair off (so all 4 are off) then switching on the other pair. A timer can be mechanical or electronic. Mechanical timers have a motor driving a disk with pegs that operate the switch. Electronic timers for times longer than a few seconds are often a counter that counts the frequency of an oscillator etc, timing out when a specific count is reached. For shorter times from a few microseconds to a few seconds a 555 timer device might do. The timer may be triggered by some event (the power came on, something pressed a button) or even by itself so the reversal is repeated over and over in a loop. This needs specific circuitry for the application. Look up relays, H bridge, 555 timer circuits to learn more.