Warning: file_get_contents(/home/content/62/10983362/html/timer-relay/wp-content/plugins/amzn/templates/kefuang/inlinesingle.html) [function.file-get-contents]: failed to open stream: No such file or directory in /home/content/62/10983362/html/timer-relay/wp-content/plugins/amzn/amzntemplates.php on line 29
Are you looking for testimonials about single coil latching relay, read the product testimonials, we will tackle various aspects, fundamentals and also other points of interest about single coil latching relay. Numerous readers find that this weblog is a good spot to start if you would like to get the prodct about single coil latching relay.
We will deliver detailed sources like critiques, photographs, articles, videos and hyperlinks which may well be of great use for those who want to make a extra detailed study about it.” should you wish to get a lot more information about single coil latching relay. just read it as under.
There was an error connecting to the Amazon web service, or no results were found for your query.
You will find loads of matters to turn into believed to be about %keywords%, and these that happen to be heavily in to the subject are most likely to decide to know considerably much more. Even when this post serves as no quite a bit more than an introduction, nothing at all stops you from placing the information to fantastic use.
BuckarooBanzai asked How to build a latching relay circuit for 2 switches and a 10 amp load?
I have a 12 volt pump (less than 10 amps) that has a single switch to operate it. I would like to add a second switch, in another location. I have been told that inserting a latching relay into the circuit would do the trick. But I am having difficulty trying to find the right one, Some say they need "reverse polarity pulses" to change the on/off state. That doesn't make sense to me, as I just want to pulse a +12 volts to the relay and change the state. Maybe I am looking at the wrong relays?
And got the following answer:
A "latching relay" is not necessarily a special type of relay. It can be a standard relay with an extra set of contacts that's used to "latch" the relay. Actual "latching relays" are partly mechanical devices and are much more expensive than standard ones. Use a momentary switch for your remote "on" switch. It of course will be in series with your coil supply and the relay coil. Now simply wire the extra pair of NO contacts on the relay in parallel with the switch. When you push the remote button, these contacts close, and current continues to be supplied to the coil even after you stop pushing the button. The remote "off" function is just as easy. You have another remote button, this one normally closed. This is wired in series with the latching relay contacts. When you push the remote "off" button, current through the "latching" contacts and hence the coil is interrupted, so the coil lets go, and the latching contacts are no longer closed. This can obviously be extended to as many remote locations as you like, all with one extra set of relay contacts and a completely standard relay. If you must use an NO switch for the "off" button, you can use a small relay at the pump location to convert this to NC. Your remote "off" button pulls in this relay, which disconnects the NC contacts on the relay, which are wired in series with the "latching" contacts on the primary relay.