Warning: file_get_contents(/home/content/62/10983362/html/timer-relay/wp-content/plugins/amzn/templates/kefuang/inlinesingle.html) [function.file-get-contents]: failed to open stream: No such file or directory in /home/content/62/10983362/html/timer-relay/wp-content/plugins/amzn/amzntemplates.php on line 29
I know you will need to need to obtain out how solid state relay crydom operates and which can be best to get, Does not it baffle your thoughts a bit, Does not it spark your curious mind, and make you believe incessantly about it, Are you enthusiastic about mastering information, trivia as well as other exciting details about it, You have come towards the correct place since each and every so often we update this web page with different details about solid state relay crydom. you could study the item information and evaluations as blelow,locate the top to purchase having a discount price .
There was an error connecting to the Amazon web service, or no results were found for your query.
Now, wasn’t that an effortless read, We hope which you identified the post as valuable as we did. It really is hard to know why some facts is written in a way that just makes it not possible to decipher. %keywords% is so important to countless folks that acquiring the correct information, the initial time, tends to make all the distinction in creating a timely option. And who has time for you to wait as of late,
when it is switched off i still have voltage(18 volts) on the output, it is rated at 120 v 2.5 amps on the output and the input (control) is 3- 32 volts DC. Im not sure if its just a bad relay , or if the amperage rating is to low . Im using the relay to turn on/off , a small air pump 120 volts / 1.5 watts. Any help with this would be appreciated
And got the following answer:
If your load were purely resistive, then the load current would be: 1.5W/120V =12.5mA But it's basically a solenoid vibrating a flapper valve, so let's assume it has a power factor of 50%. Then the VA draw would be: 1.5W/.5PF =3VA And the current draw would be: 3VA/120V = 25mA The spec sheet states that the D1202 has a maximum of 8mA leakage current in the off state. If the full 8mA leaked, you would see about: 120V x (8/25) = 38.4V. You are seeing 18 volts, so the actual leakage current is closer to 4mA (assuming the 50% power factor). The bottom line is that the D1202 most likely is working but is leaky. The voltage that you see in the off state is due to normal leakage current, but does represent wasted power.